Are you searching for Drywall Repair? Drywall, also known as gypsum board, is a material used for the construction of interior walls. It is quite durable but it is not damage-proof so holes and cracks are expected to form on the surface of the drywall. If you find out you have dents and cracks in your walls, it is high time you had a Drywall Repair.
Luckily for you, most drywall damage can be repaired easily and quickly, there might be no need to call a Drywall contractor
All you need are some basic tools, the right materials, and this step-by-step DIY which will guide and show you how to go about your drywall repair.
Tools Required For Drywall Repair
The tools and materials required for a drywall repair depend on the size of the damage. This is a list of all the tools and materials needed to fix drywall damage whether it’s a big hole or a small one.
- Drywall sander
- Drywall saw
- Paintbrush
- Screw gun
- Utility knife
Materials Required To Fix Drywall Damage
- Drywall
- Drywall screws and tape
- Joint compound
How To Go about a Drywall repair
- Firstly, using a 24-inch level, draw a square outline around the hole, and then Using a drywall saw, cut three sides of the square outline. The drywall on the remaining side of the outline can now be removed using a utility knife.
- Get a 1-by-4 foot pine board that is a bit longer than the square opening in the wall. On the ends of the board, squeeze some adhesive onto it. put the 1-by-4 into the hole with the glued surface properly facing the back of the drywall.
- After the adhesive dries, a drywall patch is cut, the adhesive is applied onto the open surface of the 1 by 4 and the patch is pressed into place and secured to the stud using drywall screws.
- Remove dust from the wall and drywall patch by wiping with a slightly dampened sponge to remove any dust. Next, apply adhesive drywall tape over the four seams of the patch.
- Using a four-inch drywall knife, apply the first layer of your choice of joint compound over the tape and allow it to dry overnight. Then smoothen the dried compound.
- Use an eight-inch knife to apply several skim coats of joint compound over the repair, and then sand it. Apply a coat of primer followed by paint.
Conclusion
If you feel the damage is beyond self-repair, you can call a drywall contractor, and the best way to get a good one is via referral from people who have used their services. For more information visit our Website.